Contrast-enhanced micro-CT to assess dental pulp tissue debridement in root canals of extracted teeth: a series of cascading experiments towards method validation.

AIM: To validate a new method for the evaluation of pulp tissue debridement in the root canals of extracted teeth using an impregnation protocol involving potassium triiodide, a radiocontrast solution known as Lugol's, combined with micro-computed tomographic (micro-CT) imaging. METHODOLOGY: The impact of NaOCl on the radiopacity of Lugol's solution was assessed using a two-fold dilution series of Lugol in distilled water and 5.25% NaOCl, which were then pipetted into transparent dishes and radiographed. To verify the influence of Lugol on the proteolytic effect of NaOCl, a dissolution test was performed using fresh bovine meat. Ten slices did not undergo any tissue processing, whilst twenty slices were fixed in formaldehyde for 24 h. After that, 10 of them were immersed in Lugol for another 24 h. Then, all specimens were placed in NaOCl and the time required for a complete tissue dissolution was recorded. For the last experiments (histological validation and micro-CT assessment), 8 extracted mandibular premolars with formerly vital pulps were immersed in buffered formalin, scanned in a micro-CT device, accessed, immersed in Lugol for 7 days and scanned again. Then, the root canals of 5 teeth were prepared and scanned, and the volume of remaining pulp tissue identified and quantified, whilst 3 teeth were histologically processed. The same specimens were subjected to histological assessment, and the images of the histologic sections were registered with the corresponding micro-CT images to verify whether the pulp tissue in the histological sections matched its counterpart in the Lugol-impregnated tissues identified in the micro-CT slices. RESULTS: There was no discernible effect on radiopacity when NaOCl was mixed with Lugol's solution. Tissue processing did not affect the time required for the complete dissolution of fresh bovine meat. Histological evaluation revealed a correlation between micro-CT and histological images confirming the identification of Lugol-impregnated pulp tissue in micro-CT images. CONCLUSIONS: The radiocontrast Lugol's solution was unaffected by NaOCl and did not interfere with its soft tissue dissolution capability. The impregnation protocol using Lugol's solution allowed the visualization of pulp tissue on the micro-CT images and the identification of pulp remnants after chemical-mechanical canal procedures.

Do pre-existing microcracks play a role in the fracture resistance of roots in a laboratory setting?

AIM: To investigate a potential cause-effect relationship between dentinal microcracks and fracture resistance of mandibular incisors that had not been endodontically treated. METHODOLOGY: Sixty mandibular incisors with circular-shaped canals were selected based on micro-computed tomographic scans to create a homogeneous sample. The cross-sectional images of the specimens were screened to identify and quantify the presence of dentinal microcracks. Then, teeth were embedded in polystyrene resin and subjected to axial compressive loading using a universal testing machine. After fracture, the roots were re-scanned and fractography analysis was performed by inspection of 3D models to verify crack propagation. Spearman's rank correlation was used to assess the correlation between the number of microcracks and force required to fracture. RESULTS: Dentinal microcracks were detected in 79% of the specimens (n = 44). The incidence of microcracks varied between teeth from 6% to 42% of the total slices per sample (average of 14 ± 17%). The number of microcracks per sample varied from 0 to 1605, with an average of 412 ± 484 (median = 221 and IQR 25% = 15/75% = 658). The load at failure values varied from 227 to 924 N, with an average of 560.3 ± 168.1 N (median = 561 and IQR 25% = 458/75% = 694). The Spearman correlation coefficient (rho) equalled 0.065. CONCLUSIONS: There was no cause-effect relationship between the number of dentinal microcracks and the fracture resistance of nonendodontically treated mandibular incisors. The presence and quantity of microcracks did not make these roots more prone to fracture.

XP-endo Finisher R instrument optimizes the removal of root filling remnants in oval-shaped canals.

AIM: To evaluate the performance of XP-endo Finisher R instruments when removing root filling remnants from oval-shaped canals using microcomputed tomographic (micro-CT) imaging as the analytical tool. Passive ultrasonic irrigation (PUI) was used as a reference technique for comparison. METHODOLOGY: Twenty mandibular incisors with oval-shaped canals were matched based on similar anatomic features of the canal (volume, aspect ratio and 3D configuration) after scanning procedures. The canals were prepared with Reciproc R25 instruments, filled with gutta-percha and AH Plus sealer using the single-cone technique and retreated up to a Reciproc R40 instrument. After retreatment procedures, the specimens were rescanned, and the homogeneity between the specimens, the oval-shaped anatomy and the remaining filling material were confirmed. The pair-matched samples were assigned to two experimental groups (n = 10), according to the supplementary approach used: XP-endo Finisher R or PUI. Each sample was scanned after each endodontic procedure. The volume of remaining root filling material was quantified before and after the use of each supplementary approach. This analysis was performed considering the total canal (Student t-test) and also by thirds (anova procedure followed by a Bonferroni correction). Data were analysed statistically with a significance level of 5%. RESULTS: The volume of root filling material at baseline was similar between the groups (t-test, P = 0.787). XP-endo Finisher R removed significantly more root filling material compared to PUI (t-test, P = 0.015), as it removed a mean of ≅32% material compared to 12% for the PUI. There was no difference in the amount of root filling material removed in the root canal thirds after using both supplementary approaches (one-way anova, P = 0.07 for XP-endo Finisher R and P = 0.886 for PUI). CONCLUSIONS: Both supplementary approaches significantly reduced the volume of remaining root filling material from oval-shaped canals. The XP-endo Finisher R instrument removed significantly more root filling material than PUI. None of the supplementary approaches was able to render oval-shaped canals completely free from remaining root filling material.

Root dentinal microcracks: a post-extraction experimental phenomenon?

AIM: To investigate the prevalence, location and pattern of pre-existing microcracks in non-endodontically treated teeth from fresh cadavers. Micro-computed tomography (micro-CT) technology was used as the analytical tool enabling full screening of the root dentine with the teeth retained in their original alveolar socket. METHODOLOGY: As a pilot study and to validate the present method, a series of 4 high-resolution scans were performed on one bone-block specimen with teeth collected post-mortem: (i) entire bone-block including the teeth, (ii) second molar tooth extracted atraumatically from the bone-block, (iii) extracted tooth dehydrated to induce dentinal defects and (iv) entire bone-block following reinsertion of the extracted tooth into its matching alveolar socket. In the main study, forty-two dentoalveolar maxillary and mandibular bone-blocks each containing 3-5 adjacent teeth (a total of 178 teeth) were collected post-mortem and scanned in a micro-CT device. All cross-section images of the 178 teeth (n = 65 530) were screened from the cementoenamel junction to the apex to identify the presence of dentinal defects. RESULTS: In the pilot study, the microcracks observable when the dehydrated tooth was outside the bone-block remained detectable when the entire bone-block plus reinserted tooth was scanned. This means that the screening process revealed the presence of the same microcracks in both experimental situations (the tooth outside and inside the maxillary bone-block). From a total of 178 teeth in the bone-blocks removed from cadavers, 65 530 cross-sectional images were analysed and no dentinal microcracks were detected. CONCLUSIONS: This in situ cadaveric model revealed the lack of pre-existing dentinal microcracks in non-endodontically treated teeth. Thus, the finding of dentinal microcracks observed in previous cross-sectional images of stored extracted teeth is unsound and not valid. It should be assumed that microcracks observed in stored extracted teeth subjected to root canal procedures are a result of the extraction process and/or the post-extraction storage conditions. Therefore, as a consequence, the presence of such dentinal microcracks in stored extracted teeth - observable in cross-sectional images of the roots - should be referred to as experimental dentinal microcracks.

Micro-CT assessment of dentinal micro-cracks after root canal filling procedures.

AIM: To evaluate the frequency of dentinal micro-cracks after root canal filling procedures with GuttaCore (GC), cold lateral compaction (CLC) and warm vertical compaction (WVC) techniques in mandibular molars using micro-computed tomographic analysis. METHODOLOGY: Thirty mesial roots of mandibular molars, with a type II Vertucci's canal configuration, were prepared to working length with a Reciproc R40 instrument and randomly assigned to one of the three experimental groups (n = 10), according to the technique used for root filling: GC, CLC or WVC. The GC group was filled with a size 40 GC obturator, whilst CLC and WVC groups used conventional gutta-percha cones. AH Plus sealer was used in all groups. The specimens were scanned at an isotropic resolution of 14.25 µm before and after root canal preparation and after root filling. Then, all pre- and postoperative cross-sectional images of the roots (n = 41 660) were screened to identify the presence of dentinal defects. RESULTS: Overall, 30.75% (n = 12 810) of the pre- + post-filling images displayed dentinal defects. In the GC, CLC and WVC groups, dentinal micro-cracks were observed in 18.68% (n = 2510), 15.99% (n = 2389) and 11.34% (n = 1506) of the cross-sectional images, respectively. All micro-cracks identified in the post-filling scans were also observed in the corresponding post-preparation images. CONCLUSION: Root fillings in all techniques did not induce the development of new dentinal micro-cracks.

Influence of aza crown ethers on the electric percolation of AOT/isooctane/water (w/o) microemulsions.

A study was carried out on the influence of different aza crown ethers on the electric percolation of AOT/isooctane/water microemulsions. A dual behavior of the aza crown ethers with regard to the percolative phenomenon was observed: low additive concentration causes an increase in the percolation temperature, whereas at high additive concentration a reduction in the percolation temperature of the system was observed. This dual behavior allowed us to define the compensation concentration, which corresponds the aza crown ether concentration at which there is no effect on the percolative phenomenon. We observed a correlation between the effect exerted by the aza crown ethers and the size of the cavity. This shows the importance of the capacity to complexate Na(+) and solubilize it in the interface and the continuous medium on the electric percolation. We also observed a correlation between the effect of the aza crown ethers on the percolation temperature and their external size. This shows the importance of their inclusion in the interface on the percolative phenomenon. Such an inclusion modifies the properties of the AOT film, facilitating the exchange of matter between droplets. A satisfactory multiparametric correlation between the compensation concentration, the distribution of the aza crown ether between water and 1-octanol, and the number of electron-donor atoms (O and N) in the crown ether was obtained. The effects have been compared with those corresponding to the crown ethers.

Caffeine intake and low birth weight: a population-based case-control study.

The authors conducted a matched case-control study to investigate the effects of caffeine intake during pregnancy on birth weight. From January to November 1992, in the first 24 hours after delivery, 1,205 mothers (401 cases and 804 controls) were interviewed and their newborns were examined to assess birth weight and gestational age by means of the method of Capurro et al. (J Pediatr 1978;93:120-2). The cases were children with birth weight < 2,500 g and gestational age > or = 28 weeks. Cases and controls were matched for time of birth and hospital of delivery and were recruited from the four maternity hospitals in Pelotas, southern Brazil. Daily maternal caffeine intake during pregnancy for each trimester was estimated. To assess caffeine intake, 10% of the mothers were reinterviewed at their households and samples of reported information on drip coffee and maté (a caffeine-containing drink widely used in South America) were collected and sent to the laboratory for caffeine determination through liquid chromatography. When instant coffee was reported, the weight of powder was measured using a portable scale, and caffeine intake was estimated from a reference table. Caffeine intake from tea, chocolate, soft drinks, and medicines was estimated from a reference table. Analyses were performed by conditional logistic regression. Crude analyses showed no effect of caffeine on low birth weight, preterm births or intrauterine growth retardation. The results did not change after allowing for confounders.